>>1971 BSA A65 New and Original Parts Hard to find motorcycle original parts

19 Фев 2015 | Author: | Комментарии к записи >>1971 BSA A65 New and Original Parts Hard to find motorcycle original parts отключены
BSA Thunderbolt A65

Dealer Ship Wont To Me — PLEASE READ

said: I had my bearings remove to my wheels powder coated. Had new installed by dealer. When I up the wheels The center axle on the fron wheel was loose, but it was before. I brought this to attention and they said were installed according to

I install the front wheel and the rings and they will not the forks (by just a hair). So I go and explain that before just slid in with no issues. So I force them in bolt everything up and as I am riding I this sqealing noise and the end starts to jerk. I stop and can it out. Take the wheel to the and they tell me the bearings

I say install they but push in just a hair more. say they have to install according to specs. I had the same clearance problems and I tell the bearing need to be in just a The second set of bearings fail just 10 minutes of riding. I them whats happening is I torque the bolt down are probably pushing on the inner of the bearing and there is no support on the which is why the axle tube is

They just not hearing I am saying. They everything me, the brakes and the way I ride. Then the says he has been doing for 15 years and he knows what he is

I am to the point of when I get them I am going to just tap them in a more. Will this be to do? The other nearest dealship or shop is an hour away.

ZX-10R_S*nner said: It might be that hour of driving to it done right though.

said: uhhhhh, bud it sounds they may have coated your bearings go in. If this is the you need the get all of it or your going to having issues

10r*ller yea make sure there is no coat where the bearins are if so just remove it with a and you could install the bearings they are kind of a PITA

BSA Thunderbolt A65
BSA Thunderbolt A65

G*Faster said: I always wheel bearings myself. not that hard, just a socket with an outside that’s a little smaller the OD of the bearing, put it against the bearing, and tap it in a hammer against the socket, sides. I agree with the two posts. make sure is no powdercoat in the area where the is seated against, and if there is, it off.

zx10x2 said: bud it sounds like they may coated where your go in. If this is the case you need the get all of it or going to keep having No coating where the bearing

ZX-10R_S*nner said: No coating the bearing goes. Yup, I read that on the first and it was the first sentence.

B*g Daddy suffice to say the 15 year moron seek another line of :thumbsup: hell i know what your talking here on the internet (but it is the internet where nobody anything) and i did stay @ a Holiday Inn lastnight. BD

*r10r said: Ask for a refund the dealership and go somewhere else. It would be worth the drive to get it right. Good luck it zx.

BSA Thunderbolt A65
BSA Thunderbolt A65
BSA Thunderbolt A65
BSA Thunderbolt A65
BSA Thunderbolt A65

Interesting articles

Other articles of the category "BSA":

Our partners
Follow us
Contact us
Our contacts


Born in the USSR


About this site

For all questions about advertising, please contact listed on the site.

Motorcycles catalog with specifications, pictures, ratings, reviews and discusssions about Motorcycles.