Kawasaki ZX7R Service Manual ZX 7R

15 Мар 2015 | Author: | Комментарии к записи Kawasaki ZX7R Service Manual ZX 7R отключены

Kawasaki Ninja ZX-7R

Only ВЈ4.99

2002 ninja zx 7r 750cc

zx7r exhaust

custom zx7r

zx 7r carbon fiber parts

zx 7r guard

zx 7r cowl cover

zx 7r decals

kawasaki zx 7r downpipes

zx 7r engine swap

kawasaki manual download


When trouble-shooting a first start with the These simple tests can for any engine. All engines need basic matters to run fuel, and air.

These simple can cause your Kawasaki to not start up or run poorly.

First start off with the Remove the hose off the tank and sure the fuel is flowing Some bikes will to turn the fuel selector to not on, or fuel will not flow. a flashlight and look down the tank, is the fuel varnished or is dirt in the tank?

Older ZX7Rs had a problem with oxidizing inside and would the screen up inside the tank. delivery may still be a trouble but we come back to that

Next Remove the spark you may need to Withdraw the tank to them. Inspect every plug as you take them All the spark plugs should the same.

If a plug looks white that piston chamber may be and not getting enough fuel.

If you a plug that looks wet and that cylinder may getting too fuel (rich) or not sparking Withdraw all the spark plugs and the plugs back into wires. Set the spark plugs on the so that they can ground Crank the bike over and the plugs for sparks, preferably dark. Make sure you at all the plugs to make sure are all sparking.

If one spark looks check the wire and plug, if old or replace them. If their is no the coil may be bad.

Kawasaki Ninja ZX-7R

If you have any test equipment as an ohm meter, you can find out what the reading should be for your coils. This way you will for sure if the coils are o.k. If the system looks fine on to the carburetors.

First, if the motorcycle has not maintained recently (a trouble in make sure the carbs are

To do this you need a vacuum made for this. Withdraw the rubber plug located the carbs and the cylinder. Attach the and take the readings from for one cylinder.

Replace the caps not measuring or it won’t run right.

Adjust the throttle screw or for that carb until all read close to one another. back to inspecting the spark If one cylinder looked lean or check all hoses for cracks and air

If the ZX7R has not been run in awhile the may be (gummed). Withdraw the float off the bottom of the carb.

Look in the for dark varnish looking If the fuel looks dark you probably have to Remove the and main jets and cautiously run a through the center hole to them out. Be careful to not the float as the peak needs to be to run well Also.

Check the small needle attached to the between the pivot point, is up and down. If it doesn’t move the carb will not fill up gas or will run low as your driving the road. Make sure you the battery As Well, if they weak the ignition system have enough power to the motorcycle running swimmingly.

If you still haven’t found make sure you valve has been checked at the correct intervals.

If not this can cause problems with the way it runs. As you can screw a compression gauge the spark plug holes and that they are within 5% 10% of other. If one is way down you have a trouble either with the bore or valves. This be a good start to finding a trouble with your ZX7R


Kawasaki Ninja ZX-7R
Kawasaki Ninja ZX-7R
Kawasaki Ninja ZX-7R
Kawasaki Ninja ZX-7R
Kawasaki Ninja ZX-7R
Kawasaki Ninja ZX-7R

Interesting articles

Other articles of the category "Kawasaki":

Our partners
Follow us
Contact us
Our contacts


Born in the USSR


About this site

For all questions about advertising, please contact listed on the site.

Motorcycles catalog with specifications, pictures, ratings, reviews and discusssions about Motorcycles.